Balusters Plinth

  • Installation:
  • It is up to the customer to use his own discretion as how to space the balusters, kindly note that the municipal building regulations should be taken into consideration due to safety factors.
  •  We recommend our specially designed pre-drilled plinths with holes at 250mm centres to achieve the correct standard spacing between each baluster. To install the above, the plinth (1.2m long) is set using normal mortar. When set the baluster is then glued down by using normal tile adhesive, this must then also be allowed to dry, before installing the coping (1,2m long) once again using tile adhesive.
  • Modcon can in no way hold itself responsible for any installation not undertaken by our official installing agents.
  • Manufactured from 25-30mpa reinforced concrete an Y10 bar, that extends from bottom of the baluster by approximately 150mm. The finish is a smooth grey off shutter concrete. Sandstone colour is available only for large orders.
  •  Click here to go to the PDF Catalogue Folder  
  • All our stock products are in AUTO CAD format and a disk is available upon your request. Our drawings can be sent by email, or one of our company representatives will be pleased to deliver a disk and explain all about our products.