How to seal concrete

If you are sealing smooth grey shutter concrete or concrete Coping, windowsills, pavers, or any concrete product we make, the preparation is the most important part. Any dust, laitance, oils, cement bloom, or dirt left behind will get trapped under the sealer and can cause whitening, peeling, or patchy areas.

Step-by-step cleaning process

  1. Let the concrete cure properly

Fresh concrete should normally cure for at least:

  • 28 days before sealing
  • Longer in cold or damp weather

If sealed too early, moisture gets trapped and causes white marks.

_______________________

  1. Dry clean first

Before using water:

  • Sweep properly
  • Blow out dust from joints and corners
  • Remove cement powder and loose debris

A leaf blower works very well.

_______________________

  1. Wash the surface

For general dirt and dust

Use:

  • Clean water
  • Soft broom or rotary scrubber
  • Mild pH-neutral detergent if needed

Avoid strong soaps that leave residue.

_______________________

  1. Remove cement haze or efflorescence

Smooth shutter concrete often gets:

  • White bloom
  • Cement haze
  • Lime staining

This must be removed before sealing.

Best method

Use a light acid-based cleaner:

  • Diluted hydrochloric acid (very weak mix)
  • Or a professional efflorescence remover

Typical mix:

  • 1 part acid to 10–15 parts water

Always:

  • Wet the concrete first
  • Apply lightly
  • Scrub gently
  • Rinse extremely well afterward

Never leave acid sitting on the surface.

_______________________

  1. Pressure clean correctly

Use a pressure washer carefully:

  • Keep nozzle moving
  • Do not blast too close
  • Especially important on smooth shutter finish

Too much pressure can etch the surface.

_______________________

  1. Allow to dry completely

This is critical before sealing.

Drying time:

  • Minimum 24–48 hours
  • Longer after acid washing or rain

Concrete must be fully dry internally, not just on top.

_______________________

  1. Final inspection before sealer

Check for:

  • Dust
  • White marks
  • Damp patches
  • Oil stains
  • Uneven colour

If water beads anywhere, there may already be contamination or previous sealer.

_______________________

Important mistakes to avoid

Do NOT:

  • Seal damp concrete
  • Use strong acid mixes
  • Use dishwashing liquid residue
  • Seal in direct hot sun
  • Apply thick coats

Thin coats are always better.

_______________________

Recommended sealers for smooth grey shutter concrete

Natural look

Use: Cemcrete SiliconSeal Solvent-Based Sealer.